DESCRIPTION
Easily and rapidly create light pulls using the Rotur Light Pull Drive Kit. With the stepped drill bit, you only need to drill the blank once. The string knot can neatly fit inside the light pull. Drill the blank a bit more than halfway with the widest part of the stepped drill bit. Then, slide the blank over the Stepped friction drive and support the other end with a pointed live centre, but be careful not to over - tighten. The Rotur Deluxe Rotating Centre is a great choice for this. Spin the blank at high speed and you're done. This kit is available in 1MT and 2MT versions and comes with a 3 - 6mm x 120mm Stepped drill.
Using the Rotur Light Pull Drive Kit is a breeze. First, with the stepped drill bit provided in the kit, drill the blank just a bit more than halfway through using the widest part of the bit. This is a one - time drill job, so you don't have to worry about multiple drilling steps. Next, slide the blank over the Stepped friction drive. Support the other end of the blank with a pointed live centre, but make sure not to tighten it too much. The Rotur Deluxe Rotating Centre works really well for this. After that, turn the blank at a high speed and you'll finish creating your light pull. When using, always handle the drill bit carefully to avoid any injuries. For maintenance, keep the drill bit clean and dry. If it gets dull over time, you may need to replace it. Also, store the kit in a dry place to prevent rusting and damage.
