DESCRIPTION
Install drawer slides quickly and effortlessly to achieve perfectly - fitting and smoothly - sliding drawers. The KREG Drawer Slide Jig eliminates the guesswork from the installation process. This user - friendly jig holds the slides firmly in place while you drill mounting holes in the cabinet, and it provides support for the drawer boxes when attaching the slides to the drawers. It's compatible with ball - bearing, epoxy - coated, and undermount slides, ensuring perfect positioning every time. With built - in tabs, it's a breeze to align the jig inside the cabinet to support the slide and to support the drawers during slide attachment. Whether you're upgrading cabinets or starting a project from scratch, mounting drawers is often a challenge. This jig simplifies the process by indexing with the cabinet frame (or side on frameless cabinets) for precise alignment. It supports the drawer slide in a level and straight position during cabinet installation. Then, it can be clamped to protrude from the cabinet to support the drawer while screwing into the drawer box. You can be confident that your slides are correctly positioned, and your drawers will operate smoothly. The jig consists of two brackets that clamp inside the cabinet, one on each side, and align with the cabinet face frame (or designated marks on frameless cabinets) for slide support during hole - drilling. These brackets are reversible, allowing them to protrude from the cabinet and perfectly align to support the drawer when mounting slides to the drawer box. This versatile jig works with almost all types of drawer slides and is suitable for both beginners and professionals. All you need are the slides, a clamp, and this jig, and you're ready to install drawer slides like a pro. Whether you're installing one or dozens of drawers, it delivers fast and consistent results. Key features include accurate slide positioning with built - in indexing tabs, repeatable results without the need for measuring and marking, versatility for use in cabinets, cases, etc., reversibility for mounting slides to both the cabinet and drawer box, secure slide - holding during work, and being made of strong yet lightweight materials for easy handling. It's designed for use in face - frame and frameless cabinets, made of plastic polymer, requires a minimum cabinet depth of 14' (35.5cm), and is compatible with ball - bearing, epoxy - coated, and undermount slides, as well as Kreg Wood Project Clamps and Face Clamps. The package includes 2 brackets, 4 pre - installed upper/lower sliders, and 1 owner's manual. It comes with a 1 - year warranty.
Using the KREG Drawer Slide Jig is straightforward. First, decide which type of drawer slides you'll use, like ball - bearing, epoxy - coated, or undermount slides. Then, clamp the two brackets of the jig inside the cabinet, one on each side. Make sure they align with the cabinet face frame (or the designated marks on frameless cabinets). This will hold the slide in place while you drill the mounting holes in the cabinet. When it's time to attach the slides to the drawer, reverse the brackets so they protrude from the cabinet. Clamp them again, and they'll support the drawer as you drive screws into the drawer box. Remember, you'll need a clamp and the slides in addition to the jig. For best results, keep the cabinet depth at least 14' (35.5cm). When not in use, store the jig in a dry place. Since it's made of plastic polymer, avoid exposing it to extreme temperatures or sharp objects that could damage it. If it gets dirty, you can clean it with a mild soap and water solution. With proper use and care, this jig will help you install drawer slides smoothly for a long time.
