DESCRIPTION
This is a set of 6 - inch replacement sanding belts (150 x 1219mm) specifically designed for the Clarke international sander CS6 - 9D. The set includes 5 pieces of fine - grit sanding belts (6502098), 5 pieces of medium - grit sanding belts (6501164), and 5 pieces of coarse - grit sanding belts (6502103). These belts offer a wide range of sanding options to meet your different sanding needs, whether it's for a smooth finish or rough material removal.
Using these sanding belts is easy. First, make sure your Clarke CS6 - 9D sander is turned off and unplugged. Then, carefully remove the old belt and install the new one. Make sure it's properly aligned on the sander. When sanding, start with the coarse - grit belt for initial rough sanding. This will quickly remove material. After that, switch to the medium - grit belt to smooth out the surface. Finally, use the fine - grit belt for a super - smooth finish. Always wear safety goggles and a dust mask to protect yourself from flying debris and dust. After use, keep the belts in a dry place. If they get dirty, you can gently clean them with a soft brush. Avoid bending or folding the belts, as this can damage them and affect their performance.
