DESCRIPTION
Boost the efficiency of realigning your lathe centers after using the lathe in 'outboard mode' with the outstanding Rotur Lathe Alignment Tool. When dealing with large workpieces, you often need to swivel the headstock. This makes it crucial to precisely realign the lathe centers when resuming turning between centers.
To realign the headstock and tailstock, simply insert the Alignment Tool into the headstock's spindle taper, just like you would with a traditional drive center. Loosen the clamp to swivel the headstock, then adjust the tailstock so that the other end of the tool fits snugly into the tailstock's spindle taper. Tighten the tailstock slightly and lock the headstock clamp to prevent further swiveling. Finally, slide the tailstock back and use the Rotur knockout bar (TKO265) to remove the tool.
The Rotur lathe centers are crafted from top - notch EN8M Steel. Its one - piece design ensures that the integral points stay firmly in place. Available in 1MT and 2MT options, this high - quality tool is proudly made in the UK by Planet Plus Ltd. 1MT: LAT1
Using the Rotur Lathe Alignment Tool is easy. First, when you've used your lathe in 'outboard mode' and need to realign the centers, insert the tool into the headstock's spindle taper just like a normal drive center. Then, loosen the headstock clamp so you can swivel it around. Move the tailstock to fit the other end of the tool into its spindle taper. Tighten the tailstock a bit and lock the headstock clamp to keep it from moving. After that, slide the tailstock back and use the Rotur knockout bar (TKO265) to take out the tool.
Here are some important things to note. Make sure to insert the tool correctly into the spindle tapers to ensure accurate alignment. When tightening the tailstock, don't over - do it. And when using the knockout bar, be careful not to damage the tool.
For maintenance, keep the tool clean and dry. After use, wipe it down to remove any debris. If it gets dirty, you can use a mild cleaning solution and a soft cloth. Store it in a safe place to prevent it from getting damaged or losing its precision.
