DESCRIPTION
The Clarke CPT1000 is a top-notch planer thicknesser, perfect for both DIY enthusiasts and trade professionals. This 254mm tool can not only finish but also size timber with ease. You'll end up with a workpiece that has the exact thickness you want, and it's straight and true. Here are its great features: It can plane and thickness timber up to 254mm (10 inches) wide. The maximum planer/thicknesser depth of cut is 2mm / 1.5mm. It can handle timber with a maximum thickness of 120mm. There's a safety on/off switch, and it has an average feed rate of 6.8m/min. The no-load cutter drum speed is 8500rpm. The fence angle ranges from 90° to 135°, and it comes with a 920x254mm table. There's also a dust extraction outlet. It runs on a 230V ~ 50Hz supply with 1500W power. It comes with a 1-year manufacturer warranty.
Using the Clarke CPT1000 Planer Thicknesser is quite straightforward. First, make sure the machine is connected to a 230V ~ 50Hz power supply. Check the safety on/off switch to ensure it's in the off position before you start any work. Then, adjust the fence angle according to your needs, which can range from 90° to 135°. Place the timber on the 920x254mm table, making sure it's properly aligned. The machine can handle timber up to 254mm wide and 120mm thick. Set the depth of cut as required, with a maximum of 2mm for planing and 1.5mm for thicknessing. Once everything is set, turn on the machine. The average feed rate is 6.8m/min, so feed the timber steadily at this speed. Remember, the no-load cutter drum speed is 8500rpm, so keep your hands and other objects away from the cutter drum. When you're done, turn off the machine and use the dust extraction outlet to clean up any debris. As for maintenance, regularly check the cutter drum for any signs of wear and tear. Keep the table clean and lubricated to ensure smooth operation. Also, make sure to keep the safety features in good working condition. This planer thicknesser comes with a 1-year manufacturer warranty, so if you encounter any problems, contact the manufacturer.
